- Wheel Bearings Remove - Clean - Re grease
- Replace engine mounting frame with new
- Balance Prop
- 3 in 1 oil all cables - check for abrasions
- Remove - clean - spray exhaust
- Recalibrate Fuel Tank mountings
- Drain - Flush and replace coolant
- Drain oil - replace filter - remove oil reservoir - remove mag plug - clean both - assemble
- Test Slipper clutch for friction settings
- replace all breather tubes and connections with new tubes
- replace all nylocs and washers with new where removed during the coarse of the rebuild
- drain - remove and clean disk brake calipers - flush - bleed air and reset brakes
- Route and replace all electrical and sensor cables
To do:
- Strip wing and replace washers and nuts that show signs of corrosion
- Replace bungee cord
- Check and re profile batons where appropriate
- Clean fabric
No comments:
Post a Comment